Temp tower for pla and petg.

thingiverse

ERROR CORRECTED!!! If you downloaded the towers, There is an error in the PETG tower, on the cylinder side. I will fix as soon as tinkercad is back up. UPDATE: I should have included, for the PETG tower, if you want to code your own, the layer change (on standard resolution) is 41, 75, 108, 141, 175, 208, and 241. Again, that's at STANDARD Quality. The PLA is the same but adds 275 as the last transition set. This temp tower allows you to see how temperatures affect stringing too. Find the right temp and then go do a stringing test. you can use the same tower if you desire. What i like about this is it shows you how each temp affects the the stringing at whatever base retraction settings you put. Makes it easier to fine tune, in my opinion.