Telescope 106mm 900mm f.l.

thingiverse

This is a 106mm diameter, 900mm f.l. refractor, based on the following components: Objective lens: https://www.aliexpress.com/item/1005001797311188.html?spm=a2g0o.order_list.0.0.7c581802rSG52C Focuser: https://www.aliexpress.com/item/32952077276.html?spm=a2g0o.order_list.0.0.7c581802rSG52C The objective lens I used is no longer available. However, this item appears to be identical: https://www.aliexpress.com/item/2251832827891886.html Note that the diameter and thickness may differ slightly from one lens to the next. The objective cell may be either too tight or too loose depending. The focuser I used is no longer available. However, this item may be a suitable substitute: https://www.aliexpress.com/item/32952109020.html This is a Crayford focuser with the same 78mmX1mm metric thread. I don't know what the back focus would be with this design. It's more expensive than the focuser I used. but it does come with a 2" to 1.25" adapter, which I had to buy separately. Finally, the star diagonal I used is here: https://www.aliexpress.com/item/3256803070978421.html The scope consists of the following 3D printed parts: Objective lens cell Objective lens retaining ring Dew shield OTA section 1 attaches to the lens cell with three #4 X 3/8" wood screws OTA section 2 mates to section 1 OTA section 3 mates to section 2 OTA section 4 mates to section 3 and threads onto the focuser with a 78mm X 1mm metric thread Mounting bar, 200mm, Vixen-style dovetail Mounting strap, bottom, 2 required. This attaches to the mounting bar with 4mm hardware Mounting strap, top, 2 required. This attaches to the bottom strap with 3mm hardware. You can choose from three variations: 1) no attachments for mounting additional accessories, 2) one additional attachment, 3) two additional attachments. The photo shows the version with two additional attachments. If you build the version with additional accessory mounts, I've included: Base plate: This mounts to the straps with M4X12mm flat head screws Vixen clamp: This mounts to the base plate with four M4X16mm flat head screws Vixen clamp part b: This sliding part attaches to the Vixen clamp with two M4X40mm pan head screws. I've included a file for a laser pointer mount. The laser pointer I used is similar to this: https://www.amazon.com/Flashlight-Outdoor-Camping-Astronomy-Hiking/dp/B0B4ZSK8JL The photo also shows my finder scope: https://www.thingiverse.com/thing:5428720 The sections and dew shield should be painted flat black inside. Prime first with white primer to avoid black paint seeping through the print. Make sure your paint is compatible with plastic. The OTA sections are glued together with epoxy. Make sure you mask off the glue surfaces. Also, try to align the sections so that they're all oriented the same relative to their printing orientation. My prints had artifacts which clearly showed the alignment. By aligning them all the same way, I was able to ensure that the overall OTA was straight. The 26mm eyepiece in the photo is not included. You can find that design here: https://www.thingiverse.com/thing:5347023 The objective lens holder and retaining ring, and OTA section 4 (and matching mask) all have threads which are best printed at 0.12mm layer height. 0.16mm might work as well. Everything else can be printed at 0.2 or 0.24mm layer height. All parts are printed in PLA, white for the OTA and dew shield, and black for everything else.