Teensy PCB board puller

thingiverse

Here's how you avoid crushed fingers when removing Teensy breakout boards: just make sure to slip each end underneath the board and rock it back and forth with a gentle pulling motion. For more control, you can snap your fingers together to grip the board - this is actually pretty reliable if you use your thumb on one side of the "PCB" word and another finger on the other. Print Settings: Rafts: No raft needed. Supports: No supports necessary. Resolution: 0.2mm is ideal. Infill: Try printing with 0% infill for the best results. Notes: Since this design doesn't require a brim, just go ahead and remove those extra lines at the end if you want your board to look sleek.