TEC3M Split Charge Relay Bracket

thingiverse

I designed this mounting system for the TEC3M because it lacks a method of attaching it to a vehicle. Print Settings Printer: Prusa i3 rework Rafts: None used Supports: No supports were needed Resolution: 0.2mm resolution was achieved Infill: The infill density is 60% Notes: I chose Rigid Ink ASA filament for its water resistance and UV protection, as it will be exposed in my vehicle. The print speed was set at 30mm/sec to prevent the printer from shaking apart. Blue painter's tape was used on the build plate. Post-Printing Additional parts required: 2 x M3 full nuts (stainless steel would be a good option, but they are not essential) 2 x M3 x 20mm bolts 3 x No6 or 3mm self-tapping screws for attaching to your vehicle.