teapot warmer (outdoor/indoor)

grabcad

I adore sipping tea, but whenever I sit outside, the candle is constantly extinguished by the gusts. Consequently, I devised this outdoor/indoor tea-warmer. A notable feature is a holder for the lighter. If you wish to print this tea-warmer, follow the Slicing-settings: • Utilize ABS (PLA will soften during use) • Set Perimeters to 0 • Employ Gyroid infill (approximately 8%, it depends on the extrusion width) • I suggest a Top solid layer of 3-4; a Bottom solid layer of at least 4 • Take into account that most settings are dependent on the printer you use