Team Losi JRX-2 Jrx-Pro, JRX-t No drill servo mount

thingiverse

No Drill JRX servo mount and shim. Uses servo tape and ties into the steering bellcrank mounts. Raises up the standoffs 1mm, they are set into a hex opening. Body of the mount is raised just enough for servo tape. Plenty of clearance for large servo saver even on chassis without cutout, and a little clearance to prevent the ballstuds on the rack from scratching up chassis. I have printed in both pla and abs. Post print prep depends on how good your setup is with bridging and supports as the raised bottom surface will require both. On abs I sanded flat then floated a few drops of acetone into the bottom of the area to be taped to make sure the bridge areas all melted together to form a strong surface for the tape to attach to. still playing with bridge and support settings to eliminate this need.