Team Associated RC10T2 Front Arms

thingiverse

Front A-Arms for the Team Associated RC10T2. They should also fit well on the RC10GT. Ream out the hinge pins with a 3 mm drill bit and then use a 1/8" drill bit. It may take several passes but make sure the arms turn freely on the hinge pin afterwards. Tap the mounting holes with a 4-40 tap. They are very close to being perfect - I still plan to tweak the design a little, but dimensionally they match up well (converting from SAE to metric was a challenge). If you can still find the original RPM arms, those would be your best choice. These should be sufficient for light bashing, depending on the material used.