Teaching Clock

prusaprinters

<p><strong>Original Post:</strong></p><ul><li>This is a remix of the Robust Teaching Clock over on Thingiverse.  </li><li>Gears were updated with spur gears generated by Fusion 360.  </li><li>Face updated with two options: inlaid or raised markings.</li><li>Drive gears update with “D” shaft to ensure proper assembly.</li><li>Assembly alignment dots added to ensure proper gear placement.</li><li>About 9 hours total print time.<br/> </li></ul><p><strong>Printing:</strong></p><ul><li>Layer Height: 0.2mm</li><li>Perimeters: 3</li><li>Infill: 15% rectilinear</li><li>Supports: no</li><li>Rafts: No</li><li>Elephant's Foot Compensation: Set to Zero for the inlaid minute marks.</li></ul><p><strong>Post Processing:</strong></p><ul><li>Inlaid pieces are glued in place with thin CA (super glue) applied with a 25 gauge blunt tip needle dispenser.  <ul><li>Blunt Tip Needle<br/><a href="https://www.amazon.com/dp/B07MTCBF2H/ref=cm_sw_em_r_mt_dp_ZZC2XQTQYYFYXYWP20Z2?_encoding=UTF8&amp;psc=1">https://www.amazon.com/dp/B07MTCBF2H/ref=cm_sw_em_r_mt_dp_ZZC2XQTQYYFYXYWP20Z2?_encoding=UTF8&amp;psc=1</a></li><li>Stick Fast CA glue<br/><a href="https://www.amazon.com/dp/B009356B92/ref=cm_sw_em_r_mt_dp_FK49YRGJGMEWF579K0JK">https://www.amazon.com/dp/B009356B92/ref=cm_sw_em_r_mt_dp_FK49YRGJGMEWF579K0JK</a></li></ul></li></ul>