Tea Light UFO night light

thingiverse

UFO P1 - print as is in your color of choice. UFO P2 - print as is in your color of choice. you may add supports to center locking ring. i printed without and then didn't use them. without supports, I would have had to do some after print work to file out the locking slots UFO P3 - print as is in your color of choice. UFO P4 - print as is in a clear filament UFO P5 - print as is in your color of choice. used to make sure top and bottom pieces (UFO P1 & P2) are properly aligned Put UFO P5 pins into the holes for UFO P2, then line up P1 and glue P1 to P2. Do not glue UFO P3, this is how you get to the 1.5 inch (38cm) tea light (I used these - https://www.amazon.com/gp/product/B09VBWK1WG/ref=ppx_yo_dt_b_asin_title_o01_s00). It should slide into the hole on top of UFO P1 and the hole at the bottom of UFO P2 should prevent the tea light from falling thru. Place on top of UFO P4 and turn to snap the locking tabs into place.