TBS V3 DJI Camera mount

thingiverse

This is a DJI HD camera mount using standoff sleeves for the TBS Source one. I like the vibration and shock reduction of a long TPU plank for mounting an FPV camera so I designed these instead of just using spacers to adapt the DJI HD camera to the existing side plates. To preserve the anti-rack attributes of those existing CF camera mount plates there are clearance notches in the standoff sleeves to allow the side place to still be in place. The two sets of camera mounting holes are at 25 and 30 degrees of camera tilt. The Matek buzzer mount fires the buzzer down through one of the openings in the bottom plate, and fits nicely in the open spot between the stack and the camera. It uses two 2mm screws in 2 existing holes in the chassis. The chin guard just slips over the screw heads on the bottom rather than be clamped under the screws as I don't want those front screws bedded in TPU and this configuration allows the best orientation of the part for printing. It stays on well for me, but I haven't needed it yet.