TBS Unify Pro32 HV VTX 30x30 Stack Mount

cults3d

I didn't feel at ease putting pressure on the VTX by placing it under the strap, so I created this 30x30 stack mount. It still has plenty of air surrounding it (vent strips on the bottom, side-entry, open top) - but I have yet to test it in the field (hopefully it won't melt the PLA!). You also still have access to the button and can see LEDs. The USB port is a bit hard to reach, but then again, you only need to cut the zip tie and lift it slightly. It's a tight fit, so one potential issue is that you need to align both the nuts on the bottom and the ones on top (which you need to screw in before placing the VTX in the mount) so that they have a flat side parallel to the VTX, and not an angle. P.S.: I originally printed one in PLA, but it shattered after a failed power loop (no direct impact, as far as I could tell), so I'm re-printing it out of PETG.