TBS Unify Pro HV Mount

thingiverse

I designed a modified version of a part I found that was intended for the Team BlackSheep Unify Pro. The Unify Pro HV is slightly larger. I also made my design parametric so I could create an identical version for the smaller Unify Pro and the Team BlackSheep CrossFire Micro Receiver. Since they are all flat on the bottom, you can mount the receiver and one of the video transmitters back-to-back on 6mm standoffs above your board. One will face toward the board, while the other will face up. Alternatively, you can mount them 90º to each other so there won't be a conflict between connectors and antennas. The holders are designed to be slightly too short for the boards. This allows the flexibility of the TPU to hold them snugly in place and still enable easy mounting on standoffs. Pictures show the Unify Pro HV mount, as that's all I had at the time, but the other mounts have been tested and function the same way. Print Settings Printer: Prusa i3 MK2 Rafts: No Supports: No Resolution: 0.20mm Infill: 20% (it won't matter, as it will print 100% infill due to its small size) Notes: Because these are deliberately sized to be too narrow for the boards so they fit snugly in place, printing them with any rigid material will not work. For video transmitters, it may be challenging to get them mounted with the pigtail installed. I recommend removing the pigtail to insert the transmitter into the mount, then reattaching it and securing it with hot glue or another suitable method. Alternatively, you can rotate the transmitter 180º so that it exits from the same side as the connector, using the mount to keep it in place if your setup allows for this.