TBS Source Two V0.1 Pod Canopy Remix

thingiverse

Upgraded frame parts & 3D prints for the TBS Source Two V0.1 are available right here! https://www.b-lineproducts.com.au/product/tbs-source-two-v0-1-upgraded-parts/\r\n\r\nI've created a remix of TopJimmyCooks' pod, and I'm aware it may not look perfect since I used tinkercad to design it. However, the extra rib at the top should provide added rigidity, while the longer fin will improve turtle mode performance. Additionally, locking my camera at 50 or 60 degrees with extra protection has been made possible by those options. If your stack is as tall as mine, you'll need 15mm standoffs at the front and 25mm at the back; otherwise, use 10mm at the front. Let me know what you think in the comments!\r\n\r\nVersion 1.1 - Original remix\r\nVersion 1.2 - Wider fin, extra ribs on sides for added strength, and a strengthened rear end