TBS Source One RunCam Hybrid 4K Camera Mount

thingiverse

This is a set of mounts for the RunCam Hybrid 4K camera on the TBS Source One frame, also compatible with standard single mounting hole micro (19mm) cameras. Files are provided for angles from 20 to 45 degrees in 5-degree increments, suitable for various flying styles, including long-range and racing. The crossbar at the bottom serves primarily to enhance print bed adhesion; it can be left intact or removed as desired. There is ample clearance behind the camera to mount a 20x20 board on the bottom plate using the holes on the v0.3 frame, particularly when utilizing HI models. On my designs, the +V, GND, VIDEO, RX, and TX leads are routed under the board, while the camera signal wire is positioned towards the rear of the quad. The SD card slot and switches are located on top of the board as mounted, with the SD card placed on the right side. If unsure, printing a HI model - only about 2mm difference - can provide clarification. Like my GPS mount for the TBS Source One, I may add files to this repository as improvements and changes are made. Feedback and suggestions are always welcome. I primarily print quadcopter parts in PETG but anticipate that this design will work well with TPU or PLA+ due to its non-high-stress nature; it is robust enough for more brittle filaments such as PLA or even ABS. Credit goes to Bambusgott for his "RunCam Hybrid Dummy" which aided me in designing this part prior to receiving my actual camera. His model can be seen within the 3D mock-up views from the design screen, along with the heavy-duty GPS mount I designed specifically for Source One frames. SEBA_P expressed concern over the 20 and 25-degree mounts not fitting properly; I have redesigned those parts, printed them, and verified that they provide adequate clearance between the camera body and the board when mounted as depicted. The 15-degree mount has been removed since it's unlikely anyone would require such a low angle, and new files for 20 and 25 degrees are now available.