TBS Source One Foxeer Box 2 mount

thingiverse

**Foxeer Box 2 Mount for the TBS Source One Frame** The Foxeer Box 2 mount is designed to fit the TBS Source One frame. Three versions of the mount are included: 25, 30, and 35 degrees. To assemble the camera, slide it in through the back of the mount. This design ensures that the camera stays securely in place during a crash unless the entire mount breaks off. The door on top of the Box can be opened with the camera still in the mount. While this may seem challenging at first, it's actually quite easy to open, and the SD card is protected from falling out due to a slight resistance that prevents it from opening easily. All buttons on the side are accessible while the camera is mounted, making it unnecessary to remove the camera from the mount for basic operations. I printed the mount with the front of the camera facing downwards and only two support towers at the tip of the front feet. **Recommended Versions** The v3 versions (25, 30, and 35 degrees) are stronger and wider, allowing the camera to slide in more easily but also pushing it towards the back of the case during crashes, making the case visible from the camera's perspective. Alternatively, the v5.1 version (25 degrees), as well as the v5 versions (30 and 35 degrees), offer easier and cleaner printing around the power button and are reduced in weight compared to the v3 versions. These models also come equipped with small bumpers at the back to prevent the camera from sliding back during a crash. The v5 version of the 25-degree mount retains the same cut-out for the power button as the v3 versions. For more information, see the change log below: **Update 14-07-2019 12:20** Added 30 and 35 degrees angle **Update 6-8-2019** Added improved version of the 25-degree mount. This new design is 6 grams lighter than its predecessor due to a reduction in overall size and thinner walls. A bumper has been added at the back to prevent the Box from sliding back during a crash, making the case visible from the camera's perspective. To further improve the design, I reinforced the back screw holes as they sometimes cracked on previous versions. I exclusively fly with a 25-degree camera angle, but due to an error in Fusion360, I had to recreate the entire design for the 30 and 35 degree versions, which I don't have time for at the moment. **Update 8-8-2019** Added improved version of the 30 and 35-degree mounts. A slight adjustment was made for easier and cleaner printing results around the power button in this version. Also added v5.1 version of the 25-degree mount with the same printing adjustment as well. If you like this design, please consider supporting me by clicking one of the affiliate links below: Tevo Flash: http://bit.ly/2PGVo0w Foxeer Box 2: http://bit.ly/2jQaPbM Foxeer Box 2 ND filters: http://bit.ly/2jQaAxr ImmersionRC Tramp HV: http://bit.ly/2K41GIR Holybro Tekko32 35A: http://bit.ly/2KcRHjt