Tatara Anet A8 upper Z bearring

thingiverse

Upper bearring for Tatara Anet A8 is now fully accessible! Use 608 bearring. This upper bearring is securely attached using two M3x15 screws and nuts, as well as two M5x15 screws and nuts. A supportive system is required (a density of 15% should suffice). In my case, the Z axle range has been maximized at 235mm. However, this value may vary depending on the specific carriage used. I strongly advise using a second bearring above the Z axle motors. After implementing these modifications and enabling autoleveling, the difference between the lowest and highest point is only 0.05mm. Although level compensation during printing is not functioning properly, every print has been exceptional - even at high speeds of 150mm/s!