Task feeder mount for bowden tube fix

thingiverse

Updated V1.1 version has been released! https://www.thingiverse.com/thing:4820250 Future updates: additional cable management pieces Original mounting place for the feeder motor on Ender style printers bends the bowden tube in a shape, that makes it spin inside the teethed couplers, chewing through the ptfe and making it lose grip. This mount rotates the feeder output to the same direction as the hot end, thus removing torque on the bowden tube. On my ender 3v2 there was just enough wire length to comfortably reach all limits of the printer, but a longer tube was needed. There is a chance you might need to extend the wires for your autolevel sensor. I used jumper wires for that. To install this mod replace the X axis limit switch cover with this one and screw it on with original screws. To rout your wires like mine, you'll need to take off the motherboard cover and striaghten all the wires that go to the hotend carriage. Cut your ptfe tube to 55-60cm in length. Move the original spool mount to the back left side, bolt it on with it's T-nuts and feed filament in from the bottom side.