TAS-Wanhaoi3Plus-Hemera_Adapter

thingiverse

This is my 1st attempt at creating an adapter for the E3D Hemera Extruder to fit the Wanhao i3Plus. Credits: < To Be Added> ATTENTION: Since the x-belt clamp connects to the lower length of the loop, you will need to reverse the direction of the x-stepper in firmware or swap the center two wires on the plug. Note: The holes for the x-axis limit switch are too far apart. I have not had time yet to make that change in the design. Future Updates: v1.5 - Add wire clips, mesh modifiers for strength at specific points. Print in Atomic Carbon Fiber PETG or Carbon Fiber PC Print Hemera Logo down and NO Supports. Supports have been included in the design. Just pop out the small rings.