Tarot 680 Pro Matek F405-Wing adapter

thingiverse

I'm using the Matek F405-Wing as a "cheap" alternative to a Pixhawk flight controller on a Tarot 680 Pro Hexacopter. Included are 3 versions of the adapter: -"Tarot680 Matek F405 mount.stl" can be fully printed in PLA as 1 piece but will require damping washers between it and the flight controller -"Tarot680 Matek F405 1_piece_mountwith hole.stl" is the same as the first version but has some material removed to save on weight. -The 3rd version is intended to be printed partly in PLA, partly in soft TPU (Ninjaflex) the goal is for the TPU to dampen vibrations. This version is comprised of two files: Tarot680 Matek F405 ninjaflexpartv2 which should be printed first in TPU, and "Tarot680 Matek F405 Non-ninjaflexpartv2" which should be printed in PLA or PETG after/over the TPU part (without removing the TPU part from the build plate) and without supports. Note: -All 3 versions are to be printed upside down without support and with a 0.2mm layer height. -When printing the non TPU part of version 3, make sure z-hop is activated and set to at least 1.6mm hitting the pre-printed TPU part.