Tardis dice tower 2 parts - few supports

thingiverse

Sliced the top off of the original model for two reasons: 1, to make sure it fit on my printer and 2, to reduce supports. The largest overhand is at the top of the model and the entire model would be surrounded in supports because of this, so I sliced the top off so that it'll print flat as a "lid" while the "base" will print mostly support-free. You will have to still print the base with supports so that the dice channel opening (where the dice spit out) will work. I manually added support blockers to the rest of the base and it printed just fine. There were some drooping bridges but you won't see it unless you're looking for it. I also added pins to the base and notches to the lid so that they'll fit together in the correct orientation. You will probably want to print the lid with supports for this reason but they are easy to remove.