Tarboor Piranha Canopy Remix M2 Dipole

thingiverse

Remix of Tarboor Piranha Canopy but with with M2 thread in mounting holes and an antenna hole big enough to hold a dipole, or let it pass through to ziptie to the back of the fin. Print in TPU. Normal supports everywhere with support blockers on the camera mounting holes will save you 15-20 minutes during printing. V3 UPDATE: It was a bummer having to replace the whole canopy if the fin gets chopped when racing with 5 inch quads so I made the fin removable to replace it easier and have the layers oriented for strength. Print the fin laying flat on the base plate. Use M2x8 bolts to mount the fin. The taller fin is about 7mm taller for more flip clearance. I changed the camera mount to a fixed 40 degree mount for the caddx ant and added some lens protection. I also adjusted the mount so it will use the same M2x8 bolts to mount the camera. The last change was to make the canopy 5mm taller to give me more clearance when using a AIO flight controller that needed a discrete RX and VTX. To make it the original height position the print at -5mm in the z axis.