Taranis X9D Thumb Style Transmitter Tray/Pad

thingiverse

Decided to design a thumb style compatible tray for my new Taranis X9D after getting accustomed to using one on my 9XR-Pro. Needed only a few extras, which included an M4x30mm bolt, an M4 nut, an M6x40 bolt/screw, an M6 nut and some CA glue and kicker. The base and end connect together using CA glue, while the end plate that stops the radio from sliding too far down can either be slid into place or glued as well. Used some foam strip to protect the radio at the base where the end plate touches and holds in place. The 45 degree "shoe" slides forwards and back so it should work for a few different radios that have the handle at the rear. This works by putting the bolt through the shoe, then this goes into the slot. The M4 nut is glued into the wing nut housing and this then tightens down the shoe from beneath to stop it from moving. A piece of foam can be added to the shoe also to assist with gripping onto the radio's handle. Used the tray for a while now and it works fantastically - couldn't see using the radio without it now that's for sure!