Taranis Removable Antenna Holder

thingiverse

I have created an adapter that replaces the original antenna on your SMA or RP-SMA pigtail cable. Simply pop out the original antenna, and you're ready to go - no modifications are needed beyond this simple swap. The connector is securely fastened in place, preventing it from rotating, making it easy to screw on or off the antenna as needed. The adapter prints well on almost any printer without requiring support material, thanks to my OpenSCAD source files. However, you may find that the fit is snug on your printer; if this is the case, feel free to adjust the measurements in the source files accordingly. To assemble the adapter, print Holder.stl twice - once normally and once mirrored - as well as Clip.stl. You can also opt to print Cap.stl for added protection. Next, place the two holders over the plug, insert the antenna through the hole, and secure it with the clip from the inside. If necessary, cover the connector with the cap and screw on the corresponding nut. If you're looking for alternative solutions that don't require any shell modifications, check out these options: * http://www.thingiverse.com/thing:1063873 * http://www.thingiverse.com/thing:1579504 * http://www.thingiverse.com/thing:1631595 If you're comfortable with using a dremel or cutting tool, consider the following alternatives: * http://www.thingiverse.com/thing:213959 * http://www.thingiverse.com/thing:733022 * http://www.thingiverse.com/thing:1130405 UPDATE (July 26, 2016): I've updated Holder.stl and Holder.scad to resolve an issue with the hex nut inlay rotation and improve the fit for a better overall experience.