Taranis external antenna mount

thingiverse

To mount an external antenna when using an external RF module, you will need this bracket in addition to some hardware components. To produce it, make sure you have M3 screw, nut and short SMA cable on hand. This bracket is intended to be positioned exactly where the photographs demonstrate how it is mounted. If you intend to mount it on the other side, just mirror the design of the part itself. To get the best print results, turn this model 180 degrees around either its X or Y axis and make sure the chamfers will face up when printing it. This should result in minimal to no post-print cleanup being required. Note: For adding a connector for an internal RF module antenna, consider this alternative design located at Thingiverse under ID number 213959.