Tapered Pin

grabcad

In SolidWorks, this practice model sketch was created with the tools line, smart dimension, fillet, corner rectangle, circle, and trim entities. The tools boss extrude and cut extrude were used to make this model 3D. To make this practice model accurate, I made the material 1060 alloy. After the first look at this model's blueprint, I pictured that the first step to create it was to sketch the outline of the model's side face. By doing this, I could easily extrude different aspects of the model different measurements. I would then continue by cut extruding on its faces. If I could redo this model, I would make sure not to sketch on the origin. I did that the first time and it caused a few problems.Mass = 825.83 gramsVolume = 305861.21 cubic millimetersSurface area = 42167.55 square millimeters