Tap Wrench / Tap Handle (M3 / M4)

prusaprinters

Basic tap handle with hollowed out ends to be able to use multiple size M3 screws.Required Hardware:2 x 22mm+ M3 screw.Print Specs:Walls / Perimeters4Infill:30% RectilinearSupports:NonePrint Orientation:HorizontalInstructions:Refer to model for exact fitment before printing, My sizing was made to be about 1.2x actual dimensions to allow for fitment and expansion.Print models horizontally, the strength of stacked layers are normally a weak point to 3d prints.Tap M3 screw holes on sides.Insert tap to ensure fit.Screw in your M3 screws until you see them both meeting in the middle of the tap chamberLoosen both M3 screw equally until your tap seats nicely.Tighten both M3 screws equally in small increments until your tap is secure, careful over-tightening.Inspired by: Lightweight Tap Handles by walter @ Thingiverse.