Tap Handle Wall Display

thingiverse

This is a fully customizable beer tap handle wall display (holder) designed to accommodate any number of handles, limited only by the size of the wall it's attached to. It uses standard 3/8"-16 bolts, measuring one inch in length and featuring low-profile nuts, along with #10 screws for wall mounting holes. To source these components, visit McMaster.com for the bolt at https://www.mcmaster.com/catalog/125/3248 and the nut at https://www.mcmaster.com/catalog/125/3297. Each section of this display can support two tap handles, except for side sections which accommodate only one. The assembly consists of a central section flanked by left and right sides. To assemble each section, you'll need two washer cover pieces and one wall screw cover. When purchasing hardware, ensure you have two 3/8"-16 bolts and two corresponding low-profile nuts. Additionally, each connection will require two pins. All parts print in the orientation specified in the model. However, center and right-hand side sections may necessitate build support at the ends featuring bridge pieces to facilitate a smooth printing process.