Tango 2 "Mantis Shrimp" FPV watch holder

thingiverse

New File Finished! This is my Mantis Shrimp design for the Tango 2. It holds a FPV watch below the controller as the gimbals would hit it if it was in the middle. The cg point was moved. It has a fold up lanyard clip so you can flip the watch up to protect the screen in transport (bottom of watch clips into the tail for use) The tail will flop down over your power button and be out of the way while its in your pocket Print in 100% TPU with support (also added a M4x8 chamfer with 2mm hex) Version 3 is the latest, it is taller and further back so your thumbs wont hit the screen during inverted yaw spins. There are 2 versions. The normal one is lower down for if you dont have folding gimbals (screen is flatter). Version 3 PRO is for the folding gimbals, it has a raised mount to accommodate folding gimbals (I added a tail storer too, but this is untested) There are 2 ways to use this, With the screen right behind the Antenna (not recommended for range), this will have a front heavy balance point, if you pivot it around 180 then you have the second position where the screen is below the remote. Personally to store I rotate 180 from the bottom to the top orientation, then fold the tail down using the screen's recess to pin it (Pro gimbals under screen)