Tandy 1000 EX Expansion cover

thingiverse

This is a replacement part for Tandy 1000 EX computers. This is the initial version and is imperfect at this point. The rear cover does not have the same dimensions as the original piece and as a result it doesn't cover the back slot 100%. Fortunately, since it is a bit smaller, this doesn't prevent the piece from fitting otherwise. The length of the piece appears to be slightly shorter as well which leaves a small gap in the front. Printing: This was printed face-down with supports so that the curve goes up. With my current settings, my Ender 3v2 really struggled to print the supports quite right. The main reason for supports are the wings on the back curved part that slot in to the back. You may be able to get by without supports in this area, but the front part also a lip that slides in to the front of the computer chassis. My support did fail on the front, but the lip seemed to print well enough- just something to keep in mind.