Tamiya TT-02 Adjustable Suspension Arms

thingiverse

Hi guys, These are adjustable upper suspension arms for the Tamiya TT-02. You'll need 4 M3x25mm screws to assemble them. I used some gel super glue to anchor the screw in the inner end so that adjustments work more reliably when you only disconnect the outer end. The screws I used give about half a degree of camber adjustment per full turn, which is fine for my purposes. If you're using my rear arms, go with an upper arm that is close to the toe you're using. Half a degree off doesn't have much effect, so I only included 3 (0, 1, 2). If you want to run a lot of camber you'll need to deal with the change in steering arm length. I included 3 steering arms for a variety of geometry. Add a degree of camber, use V2, 2 degrees V3. Ride height also varies the steering link length requirement, so your mileage may vary - I'm running a higher than normal ride height. Normal ride height lets you run V1 or V2 steering arms. Obviously, if you have a way to make adjustable steering arms, you're laughing. Use at your own risk. Wrench to drive or drive to wrench?