Tamiya Holiday Buggy narrowed front suspension DT-02 DT02

thingiverse

The standard front suspension takes on a quirky appearance due to its extremely wide tread. This is where the adjustable wishbones come in – they can be swapped out for a narrower set that dramatically reduces the tread's width by 20mm on each side. To replace these, you'll need one new tie rod. Since the existing short tie rod can be repurposed as the long rod, all you'll need is a new short tie rod to complete the swap. These are left-hand wishbones, but they can easily be flipped over for use on the right-hand side due to their identical design. However, I printed the right-hand wishbones with mirrored dimensions to compensate for the slightly rough finish at the bottom of my prints.