Tamagotchi Care Robot - With Kill Mode

prusaprinters

Code: https://github.com/JensMakerAdventures/Tamagotchi-Incubator Can be printed without supports, I used PLA. If you use black material maybe you don't need a shield in the back. I did need this because the backside reflected light into the screen making it hard to do vision. As the models are, the camera might not align with the tamagotchi so you need to wedge some material in between.I used m2 threaded inserts, bolts and nuts for this project. Main parts:Plexiglass 3mm thicknessRaspberry Pi 33.5inch RPi LCD, 480x320, IPS, Resistive TouchscreenRaspberry Pi Camera Module 2 - 8MPLISIPAROI White LED ring for RPi CameraRaspberry Pi GPIO Edge connector(2x40-pins) (for splitting GPIO)DSI/CSI Flex cable for Raspberry Pi - 61cm (could have been way shorter)40 pins Rainbow GPIO cable extender male/female - 10cm (I had to use dupont since this was sold out at the time)3x SG90 servoSome tiewraps for cable managementDupont connectors for Raspberry Pi <-> Light RingI2C PCA9685 12-Bit 16 channel PWM/Servo Driver board