Talon Claw Bullpup Rmax 1 with Bearing Shuttle for EXTENDED U-CHANNEL

Talon Claw Bullpup Rmax 1 with Bearing Shuttle for EXTENDED U-CHANNEL

thingiverse

This is a remix of Captain Slug's RMAX 1 system adapted to the Talon Claw U Bullpup blaster. Please note - this system is used with the FULL LENGTH U channels (same length as standard Caliburn U). NOT compatible with the TCUB U channel length. There are mounting points to use 4x12x4mm bearings. Mount with 4-40 screws. There are recessed oval sections for Teflon mouse feet to be used on the shuttle section where it meets the barrel. Teflon mouse feet are not critical to the shuttle operation. There an option to reduce friction and noise between the barrel and the shuttle. Either the single 5 rail can be printed multiple times, or the double rail is two 5-rails merged. In total, the rail system is 5 x 5 rails, and the 6 rail. OR, 2 x double rails, 5 rail and 6 rail. I printed my rails at 7 walls / 7 floors / 7 ceiling. (0.2 walls), 30% infill. Increased density may be required to reduce bowing of pieces due to the "rail" nature of the print. Picatinny sections will be updated shortly. Shroud is still in testing phase, but should be fine -- it's Slug's standard Rmax 1, except for the front and rear piece. They've been edited to compensate for the U-channels larger Muzzle. NOTE: muzzle and front mag are different than Slug's. I've added pin holes to match up to the Rmax rail. NOTE 2: Pin holes are 1.9mm (tight). I recommend heating them for a few seconds vs. hammering them in. NOTE 3: 18" of rod is required vs the standard length. NOTE 4: Not happy with bearing travel noise. Alternate full Teflon feet version coming.... Find me on Caliburn FB if you have any questions....

Download Model from thingiverse

With this file you will be able to print Talon Claw Bullpup Rmax 1 with Bearing Shuttle for EXTENDED U-CHANNEL with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Talon Claw Bullpup Rmax 1 with Bearing Shuttle for EXTENDED U-CHANNEL.