Taller Foot For Lian Li Tu-150

thingiverse

Wanted a taller foot for my my tu 150 case so i would be able to fit two fans under the case blowing into the area where the graphics card sucks in air. Now the Gpu has access to fresh air instead of sitting in its own exhaust. I had a temp reduction of it thermal throttling at 100c to a 68c. The Gpu is a asus 3070 tie. I added a thermistor to the heat sink of the graphics card so the fans spool up when it gets hot. Printing: Scale so it is 1.69 inches tall. Sometimes a slicer scales it oddly. Other than that, print however you want. Use the screws that came when you removed the normal foot and you can remove the aluminum trim piece as well and rubber pad. Install them all onto the new foot.