Tall Lithophane Stand for USB Light

thingiverse

I'm absolutely thrilled with the Lithophane Stand for USB Light from mrwilluk, having successfully printed it over twenty times now.\r\n\r\nHowever, some of my lithophanes are quite tall, and unfortunately, the light just wasn't reaching all the way up as expected. So, I decided to make a few tweaks by increasing the height of the light section by 15mm. Additionally, I encountered an issue with thicker USB cords not fitting through the hole at the rear of the stand, so I expanded that hole to 6.5mm.\r\n\r\nFortunately, any width or height will yield the same curve as you would achieve using http://3dp.rocks/lithophane/. If you select the OUTER CURVE and opt for a maximum thickness of no more than 2.6mm, this stand will perfectly fit your lithophanes.