tall foot

thingiverse

I noticed that the fan grills were alarmingly close to the table holding the printer, which severely hinders ventilation. Upon closer inspection, I discovered that printing the small nibs used by the original poster was not possible due to a design flaw. The "tall foot" model boasts a substantial 12.1mm post in its center, lacking any nibs altogether. As a result, the finished part is likely to be quite snug and may necessitate the use of a clamp to secure it into the central hole of the leg. Elevating the printer by 5cm or 50mm is also achievable with this modification. This upgrade should be compatible with the LK4 Pro and Alfawise U30 models, and potentially many others.