Tall Feet for Corsair 400Q

thingiverse

Tall feet for the Corsair 400Q computer case. Increases overall height 100mm. Uses the same screws as the default feet. I'll be honest, these are beefier than they need to be. For me, I'd prefer to waste some filament and be sure my PC won't collapse. I printed with a support for the entire length of the screw hole but it was really hard to remove. Uploaded version prints 1 layer (assuming 0.2 or 0.3mm layer heights) across the hole with no support you can later punch through with a screw or screwdriver. After slicing just check that the hole is covered by only one layer of material. You'll need a long screwdriver to install. I used 6 of these rubber pads per foot for extra friction https://a.co/d/5JZDl9p but you probably don't them if used on carpet or aren't worried about sliding.