Talentcell Booster Box Mounting Shelf & Bracket Version 1.0

thingiverse

Here’s the solution I came up with for mounting a de-cased Talentcell YB1206000-USB battery into the Q-pack MK3. I modeled and printed a plate to make use of the void in the bottom Booster Box. It fits very snugly into place and even slots over the raised seams underneath, almost snapping into place. It also tags into 2 of the M3s that are in the box. So two M3s and a good amount of 2-part epoxy hold this mounting surface in place very solidly. I remixed Michael Fienen's Talentcell board bracket to mount and sit on top of a raised platform, allowing full access to the ports and switch. This configuration also points the led battery meter towards the motherboard, which could be viewed if you add a small slot to the motherboard. The raised platform also allows room under the board for running wires through this compartment. ****Warning!**** I do not suggest installing this in the manner that I did until your booster tube is installed, as you will lose access to the area inside the box where it is glued in place. FYI: Installation also included removing several M3s inside the booster box to allow the plate to be installed and then re-installed afterwards.