Tal.0/short dart Spring - 3D printed spring for Tal.0 half dart mag

thingiverse

This is a spring I designed for the Tal.0 Nerf Mag by zackfreedman, since I don´t have access to a drum spring. Because this is a spring made of plastic, it can deform if under pressure for a longer time, the spring also limits the capacity of the Tal.0 because it is intended to use a drum spring, but it is a great temporary solution. It should also work with other short dart mags but you might have to adjust it. Version 1 is with 235mm a bit too short but I will change that soon, until then print it with 245mm length, you should adjust this in the slicer. Printing: The current Model relies on Vase or Spiral Mode, I may add a Model that doesn't need it if it gets requested. In PrusaSlicer it works with a Resolution up to 0.20, you really don't need detail. I used PETG but PLA should work fine Don't forget to remove the bottom layer in the slicer or it doesn't work.