Tail Fin - Tiny Trainer FliteTest

cults3d

Tail fin for the Tiny Trainer from FliteTest. This "thing" was actually created because I needed a little more weight at the rear to better balance the center of gravity. However, it also protects the original tail fin, which consists of a foam plate. The infill can be adjusted depending on the weight required. I printed with 50% PETG infill. The tail fin was attached with hot glue. Tail fin for the FliteTest Tiny Trainer. This "thing" was actually created cause I needed a little more weight at the tail in order to compensate the center of gravity. However, it also protects the original rear fin, which consists of a foam board. Depending on the required weight, the infill can be adjusted. I have printed it with 50% infill made of PETG. The tail fin was attached with hot glue.