Tablet Teleprompter/Reading Stand

thingiverse

I was in desperate need of a stand that could support my iPad at 65 degrees for teleprompter or reading purposes. Fortunately, it works flawlessly at that angle for both applications and can be easily assembled at home using glue or disassembled for travel by pressing the parts together. Print Settings Printer: Rigidbot Rafts: Doesn't Matter Supports: Yes Resolution: 0.3mm Infill: 25-30% Notes: Print in ABS or PLA with a 25-30% infill ratio. It's recommended to print only the All file for optimal results. To ensure proper alignment, rotate the arm to lay flat if printing separately. Enable support for either the arm or the entire assembly to prevent defects. For permanent use, apply glue to secure the parts together. Post-Printing Carefully remove support material from the ends of the arm after printing is complete.