Tablet Teleprompter/Reading Stand

pinshape

I Required a Stand that would Hold My iPad at 65 Degrees for Teleprompting or Casual Reading. This Device Works Perfectly in That Angle for Either Task and Can be Locked Together for Home Use or Disassembled for Travel. Print Settings: Printer - Rigidbot, Rafts - Irrelevant, Supports - Yes, Resolution - 0.3mm, Infill - 25-30%. I Recommend Printing the All File Only with ABS or PLA and 25-30% Infill. The Arm Must be Rotated to Lie Flat if Printed Separately. Support Material Should be Turned On for the Arm or Entire Assembly When Printing Everything. To Assemble, Simply Push Fit the Arm into the Two iPad Frames. For Permanent Use, I Recommend Gluing Them Together. Post-Printing Instructions: Remove All Support Material from the Ends of the Arm.