Tablet adapter for DJI Mini 2 transmitter

thingiverse

Designed this stand to use an ipad or other tablet with the DJI mini 2 transmitter. The stock transmitter fits large phones but not tablets. This is a prototype and I have only tested it with one tablet (buddies ipad pro). The best way to use it seemed to be to utilize the strap on the back of his case to hold the top side of the tablet in place. I intended for gravity to mostly hold the tablet in place but with no case on, it slides around easily against the PLA. If it will not hinder the screen too much, a simple rubber band can be used around the top of the tablet to hold it in place. A longer cord will most likely be needed to reach the charging port of the tablet. What do you guys think? Is this concept viable or does it need a better clamping system to hold the tablet in place? Printing: Print with the large face of the main part facing down, this will require a rotation in the slicing software. Printing this way will get rid of the need for supports. I printed the clamping block (the part that goes where the phone goes) with 100% infill and the rest with 70% (this can be done with the blocking tool in cura). I was worried about weak spots, but after printing, I think I could have used less infill. Print the bottom piece (smaller stl file) with the pins facing upward and no supports will be required. Print time was 24 hours and 48 minutes for the main section and about 2.5 hours for the other section.