Table Top Modular Remote Holder

prusaprinters

<p>This is a modular remote control holder designed to sit on a table top.&nbsp;</p><p>There are 4 different width boxes. The box widths are 44mm, 54mm, 88mm, and 108mm. Each width has the option of a depth of 20mm, 30mm, 40mm, and 50mm.&nbsp;</p><p>There is a rail piece that each box slides on. You can adjust the length of the rail in your slicer by scaling that dimension. The boxes fit along the rail in the 20/30/40/50 dimension and these are the dimensions of the outside of the box so the rail can be scaled in length by multiples of 10mm to reach your desired length.&nbsp;</p><p>The 88mm and 108mm boxes have holes for 2 rails so that you can use them as end pieces and have 2 rows of either 44mm boxes or 54mm boxes.&nbsp;</p><p>There is also a double rail which is just 2 rails stacked on top of each other. This allows you to create your own bracket that can attach to the rail if you wanted to.</p><p>The rail can be printed either vertically or horizontally. If printed vertically, you will not need any supports but will most likely need a brim. If printed horizontally, then you will need supports and I recommend printing with one of the open sides down.&nbsp;</p><p>The boxes will need support for wither the inside or the rail depending on orientation of the print. Also note that the top of the rail also acts as the the base of the inside of the box.&nbsp;</p><p>Happy Printing!</p>