Table glass holders

thingiverse

I found this remix on [3DToday](https://3dtoday.ru/3d-models/detali-dlya-3d-printerov/raznoe/derzhatel_originalnogo_stekla_dlya_creality_ender_3/).\r\n\r\nThese holders were designed to replace paper clamps for holding the glass on the table.\r\n\r\nOf course, such holders reduce the useful square footage of the table. Still, they are better than paper clamps.\r\n\r\nI use these holders on my Ender 3 with an aluminum table that is 3mm in height.\r\n\r\nThe holders come in two sizes: one for glass 3mm and another for glass 4mm (considering the metal table's height).\r\n\r\nYour solution may vary. Use this image as a reference only.\r\n\r\n_Note: I didn't place the holders on the left side because Cura defaults to generating a "warm-up lane" there, which would cause the extruder to hit the holders._