T8 8mm lead screw bit for z-rod

thingiverse

This is the T8 nut driver bit with a 1/4 inch hex size and an 8mm hole, use it with the cordless electric screwdriver to move the z-rod lead screw nut or x carriage attached to the screw nut.\r\nIf the rod holder has six sides then it becomes a standard nut driver bit. Otherwise, the default setting is for sixty-four sides on the T8 rod holder. The height applies only to the hex bit and not the rod holder, so the actual height is roughly double that of the bit itself.\r\nManufactured using PLA with a diameter of 40mm, 100% infill, and a brim of 10mm. No support was needed for this print.