T5 80 Zähne 8er Bohrung

thingiverse

Customized version of http://www.thingiverse.com/thing:16627 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the following settings: Motor shaft diameter is set to 8 millimeters. Retainer teeth are enabled, totaling 1 tooth. Idler teeth are enabled, also totaling 1 tooth. Additional tooth depth is disabled at 0 millimeters. Retainer height is adjusted to 1.5 millimeters. Number of nuts on the motor shaft is set to 1. Pulley bore diameter is specified as 40 millimeters. Total number of teeth is set to 80. M3 nut flat width is defined as 5.7 millimeters. Additional tooth width is adjusted to 0.2 millimeters. Diameter of M3 nut is set to 3.2 millimeters. Distance from motor shaft to nuts is set to 1.2 millimeters. Angle of the M3 nut is fixed at 90 degrees. Depth of the M3 nut is specified as 2.7 millimeters. Idler height is adjusted to match retainer height at 1.5 millimeters. Pulley bore height is set to 8 millimeters. Total thickness of pulley teeth is set to 12 millimeters. Profile selection is set to 6.