T35 TRITIUM VIAL REFLECTOR MOUNT

grabcad

Human: V1.0 you must use super glue to secure the vial supports in place if they're attached as shown, flush with the bottom, since the focal point is extremely close, less than one inch away if you position them right next to the reflector it creates a beam of light that's focused, almost like a flashlight shining about six inches ahead use super glue on a piece of unwrinkled aluminum foil cut to fit i'll update this model so you won't have to use super glue to hold the arms in place and maybe even allow for adjustable focal points Printed on an unmodified Creality CR-10 with Esun PLA+ (pro) in black at 0.2mm layer height, no supports, 30% infill note: you could print the reflector at a lower resolution for a smoother finish but it works well even at 0.2mm Post Processing: setting the focal point by extending the arms so they're flush with the bottom of the reflector will give a very close focal point of less than one inch retracting them all the way so they touch the reflector will create a more directed beam like a flashlight vitamins you'll need are a T35 3.5x25.0mm Tritium vial i recommend only getting green ones since other colors will be significantly dimmer, about 80-15% less bright