t2.5_40

thingiverse

Customized version of http://www.thingiverse.com/thing:16627 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the following settings: m3_nut_hex = 2 idler_ht = 1.5 inches higher retainer = none required m3_nut_flats = exactly five and a half turns pulley_t_ht = twelve inches tall no_of_nuts = one big nut needed nut_angle = perfectly horizontal at ninety degrees additional_tooth_depth = adding no extra depth pulley_b_ht = eight inches in height profile = choosing the sleek option five additional_tooth_width = increasing by a small two tenths of an inch idler = leaving idlers out altogether m3_dia = making them exactly three and two tenths inches wide nut_shaft_distance = positioning one and two tenths of an inch away from center m3_nut_depth = sinking them two and seven tenths inches deep into place teeth = setting forty precision-made teeth on each gear pulley_b_dia = keeping pulleys twenty inches around motor_shaft = mounting motors four big, strong inches long