t-trak corner foot drill guide

thingiverse

This is a step-by-step guide for crafting corner feet on a T-trak railroad module, eliminating the need for a drill press. The goal is to cut and rip 2x4s into precise shapes, then utilize this guide to drill holes, followed by hammering in t-nuts and gluing them into place with hex or carriage bolt feet. To get started, you'll need a few essential tools: this drill guide, a miter saw for cutting the feet, and a drill equipped with a 5/16" drill bit. Follow these instructions to create your corner feet: 1. Cut your 2x4 into 2-inch pieces using a miter saw (clamp a scrap 2x4 section in place as a template for accuracy). 2. Chop each piece precisely in half with the miter saw, working in pairs. 3. Use this drill guide to accurately drill holes where needed. 4. Hammer t-nuts into place and seal around the perimeter with glue. Once you've completed these steps, your corner feet are ready for use in your module construction project!